T3D-007-015 Cable Trunking 350mm C1.43 Cable Path Kit

Trackside 3D SKU: T3D-007-015

No reviews

$2.99 USD

Available Now!

Trackside 3D's Cable Trunking System can be used to route wiring around your layout or used for scenic purposes. All of our trunking systems are scaled down versions of Network Rail RT/E/PS/0013 standards to 1:76.2 scale. The 350mm sizing denotes the full-size prototype interior width of the trough. We recommend the 250mm and 350mm rated systems with 0.64 (22 AWG) wiring or smaller diameter wire when using the system to route wires. It works well for hiding wires to/from the track, as well as signals, detectors and other electronics. Each of our trunking kits includes a scale lid, a single trough section (1m scaled down to OO scale), and a 10x trough section (this is equivalent to 10m of cable trough on the real full sized railway). We have additional products that provide cable routing holes in single trough sections and low-profile lids which allow for added wire capacity.

This kit is designed to be used with C1.43 Cable Trunking Kit T3D-007-006, this kit provides low profile lids and single cable trough components with cable routing / cable path holes. These troughs are used to route cables to other equipment.

C1.43 350mm Concrete Cable Trunking Cable Path Kit includes object files to print:

  • Single C1.43 Concrete Cable Trough with large cable hole
  • Single C1.43 Concrete Cable Trough with large cable holes (both sides)
  • Single C1.43 Concrete Cable Trough with scale cable holes (both sides)
  • Single C1.43 Concrete Cable Trough Lid with cable paths
  • Single C1.43 Concrete Cable Trough Low Profile Lid with cable paths
  • Single C1.43 Concrete Cable Trough Low Profile Lid without cable paths

Type: C1.43 (350mm)

C1.43 Trunking:

  • Base w/ single large hole - 13.1mm x 5.8mm x 4.5mm
  • Base w/ two large holes - 13.1mm x 5.8mm x 4.5mm
  • Base w/ scale holes - 13.1mm x 5.8mm x 4.5mm
  • Low profile Lid with cable paths - 13.1mm x 5.8mm x 1.5mm
  • Low profile Lid without cable paths - 13.1mm x 5.8mm x 1.5mm
  • Lid with cable paths - 13.1mm x 5.8mm x 2.5mm

Recommended Material: PLA or Cement textured PLA

 3D Printed Component Print time (30mm/sec) Material Used
Single C1.43 Trough (Scale) 6 minutes 0.06m (<1g)
Single C1.43 Trough (Large - 1) 6 minutes 0.06m (<1g)
Single C1.43 Trough (Large - 2) 6 minutes 0.06m (<1g)
Single C1.43 Lid w/Cutouts 4 minutes 0.08m (<1g)
Single C1.43 LId Low Profile w/ Cutouts 4 minutes 0.06m (<1g)
Single C1.43 Lid Low Profile no Cutouts 4 minutes 0.06m (<1g)

 

  1. Trackside3D Small Object Profile
  2. Supports Disabled
  3. Build Plate Adhesion - skirt, brim or none (recommend: skirt)
  4. Infill >= 60% (recommend: 100%)
  5. Layer Height between 0.1mm and 0.12mm (or better)