T3D-007-013 Cable Trunking Tee 350mm C1.81

Trackside 3D SKU: T3D-007-013

$1.99 USD

Available Now!

Trackside 3D's Cable Trunking System can be used to route wiring around your layout or used for scenic purposes. All of our trunking systems are scaled down versions of Network Rail RT/E/PS/0013 standards to 1:76.2 scale. The 350mm sizing denotes the full-size prototype interior width of the trough. We recommend the 250mm and 350mm rated systems with 0.64 (22 AWG) wiring or smaller diameter wire when using the system to route wires. It works well for hiding wires to/from the track, as well as signals, detectors and other electronics. Each of our trunking kits includes a scale lid, a single trough tee section (1m scaled down to OO scale), and XL trough lid (this is slightly deeper for easy assembly). 

Note: The image of the lid shows the inside of the lid, the outside side is flat.

C1.81 350mm Concrete Tee Cable Trunking Kit includes object files to print:

  • Single C1.81 Concrete Cable Trough Tee
  • Single C1.81 Concrete Cable Trough Lid
  • Single C1.81 Concrete Cable Trough Lid (deeper)

Type: C1.81 (350mm)

Compatibility: Use with C1.43 straights and C1.82 curves

C1.81 Trunking:

  • Single Tee Base: 13.1mm x 8.8mm x 4.5mm
  • Lid: 13.1mm x 8.8mm x 1.1mm

Recommended Material: PLA or Cement textured PLA

 3D Printed Component Print time (30mm/sec) Material Used
Single C1.81 Tee Trough 12 minutes 0.32m (1g)
Single C1.81 Lid 9 minutes 0.31m (1g)
  1. Trackside3D Small Object Profile
  2. Supports Disabled
  3. Build Plate Adhesion - skirt, brim or none (recommend: skirt)
  4. Infill >= 60% (recommend: 100%)
  5. Layer Height between 0.1mm and 0.12mm (or better)